Renesas User System Interface Board HS7047ECH61H Instrukcja Użytkownika Pobierz pdf (Strona 80)

4.3 Diagnostic Test Procedure Using the Diagnostic Program

Insert the CD-R (HS7046EPH60SR supplied with the E6000H) into the CD-ROM drive of the host computer,

move the current directory to <Drive>:\Diag with a command prompt, and enter one of the following commands

according to the PC interface board used to initiate the diagnostic program:

1. PCI bus interface board (HS6000EIC01H or HS6000EIC02H)

> TM7046

–PCI (RET)

2. PC card interface (HS6000EIP01H)

> TM7046

–PCCD (RET)

3. LAN adapter (HS6000ELN01H)

> TM7046

–ELN (RET)

4. USB adapter (HS6000EIU01H or HS6000EIU02H)

> TM7046

–USB (RET)

The High-performance Embedded Workshop must be installed before the test program is executed.

Be sure to initiate the diagnostic program from <Drive>:\Diag. Do not initiate it from a directory other than

<Drive>:\Diag, such as > <Drive>:\Diag\TM7046

–PCI (RET). If the diagnostic program is initiated when the

current directory is not <Drive>:\Diag, the diagnostic program will not operate correctly.

When

–S is added to the command line such as > TM7046 –PCI –S (RET), steps 1 to 14 will be repeatedly

executed. To stop the execution, enter Q.

Notes: 1. <Drive> is a drive name for the CD-ROM drive.

2. Do not remove the CD-R from the CD-ROM drive during test program execution.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 242 243

Brak uwag

Renesas User System Interface Board HS7047ECH61H Instrukcja Użytkownika Strona 80