Renesas User System Interface Board HS7047ECH61H Instrukcja Użytkownika Pobierz pdf (Strona 126)

3.7.2 Setting an On-Chip Breakpoint

Use the [On Chip] sheet on the [Event] window to display, change, or add settings for on-chip breakpoints.

Select [Add...] or [Edit…] from the popup menu displayed on the [On Chip] sheet. The [Breakpoint Properties]

dialog box (the [On Chip Break] page) will appear.

Figure 3.22 [Breakpoint Properties] Dialog Box ([On Chip Break] Page)

[Sequential Break]: Use this item to specify a sequential break consisted of on-chip breakpoints. A

sequential break allows breaking the program when the conditions of several channels

are satisfied sequentially. Two to four points can be selected for this function. The

conditions are satisfied from 1 to 4, in order. Check a box to use the sequential break

function (select 3 to use two points, 2 to use three points, and 1 to use four points).

[Address Range Break]: Selecting a combination of channels specifies the break range. Select either of the

followings:

4-3: Channels 4 and 3 are used to specify the break range.

2-1: Channels 2 and 1 are used to specify the break range.

[Run time count between trigger outputs]:

Measures the time between two points by using channels 3 and 4. After channel 3 has

been satisfied, the time is measured when channel 4 is satisfied. The result is

displayed in [RunTime Count] on the [Platform] sheet of the [Status] window.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 242 243

Brak uwag

Renesas User System Interface Board HS7047ECH61H Instrukcja Użytkownika Strona 126