Renesas Emulator System SH7362 Instrukcja Użytkownika Pobierz pdf (Strona 31)

E8a Emulator User's Manual 3. Preparation before Use

R20UT0541EJ0601 Rev.6.01 Page 31 of 124

Aug 25, 2011

3.6 Connecting the Emulator to the User System

Use the procedure below to connect the emulator to the user system with the user system interface cable, or to disconnect

them when moving the emulator or the user system.

1. Check that the host computer is turned off or the emulator is not connected to the host computer with the USB cable.

2. Connect the user system interface cable to the user-side connector of the emulator.

3. Connect the USB cable to the host-computer-side connector of the emulator.

(1) The connector must be installed on the user system. Table 3.2 shows the recommended connector for the emulator.

Table 3.2 Recommended Connector

Type Number Manufacturer Specifications

2514-6002 3M Limited 14-pin straight type

Note: When the connector is installed on the user system, do not install any components within 3 mm of the connector.

(2) The pin assignments of the connector are shown in the section of ‘Pin Assignments of the E8/E8a Connector’ in the

additional documents for the E8a emulator user’s manual.

Pin 1

Pin 2

User system

Connector

User system interface cable

Figure 3.9 Connecting the User System Interface Cable to the User System

Notes: 1. To connect the signals output from the E8a connector, refer to the MCU pin alignment.

2. To remove the user system interface cable from the user system, pull the connector upward.

3. The range of frequencies that the emulator operates at is different according to the MCUs used.

4. Connect the signals from the E8a connector as shown in section 3 or section 4 in the additional documents

for the E8a emulator user’s manual.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 123 124

Brak uwag

Renesas Emulator System SH7362 Instrukcja Użytkownika Strona 31