Renesas Emulation Pod M306H2T-RPD-E Informacje Techniczne Pobierz pdf (Strona 22)

M306H5T3-RPD-E User’s Manual 2. Setup

REJ10J0866-0100Z Rev.1.00 Dec.16, 2004

Page 20 of 66

2. Setup

This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change

settings.

2.1 Removing/Attaching the Upper Cover

To use this emulation pod with your user system, it is necessary to set as follows. Set the following after removing the upper

cover.

 Input frequency

 Switches

 Mounting/removing network resistors for pullup

(1) To open the upper cover, remove the four screws of both sides of this product and lift off the upper cover (see Figure 2.1)

(2) To close the upper cover, attach the upper cover and secure the four screws of both sides of this product.

Figure 2.1 Removing the upper cover

CAUTION

Note on Removing and Attaching the Upper Cover:

 Always shut OFF power when removing/attaching the upper cover or changing the switch settings.

Otherwise the internal circuit may be damaged.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Brak uwag

Renesas Emulation Pod M306H2T-RPD-E Informacje Techniczne Strona 22