Renesas SH7210 Series Instrukcja Użytkownika Strona 62
- Strona / 90
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
56
6. If a condition of which intervals are satisfied closely is set, no sequential condition will
be satisfied.
• Set the Event conditions, which are satisfied closely, by the program counter with
intervals of two or more instructions.
• After the Event condition has been matched by accessing data, set the event
condition by the program counter with intervals of 17 or more instructions.
7. If the settings of the Event condition or the sequential conditions are changed during
execution of the program, execution will be suspended. (The number of clock cycles to
be suspended during execution of the program is a maximum of about 102 bus clock
cycles (Bφ). If the bus clock (Bφ) is 66.6 MHz, the program will be suspended for 1.53
μs.)
8. If the settings of Event conditions or the sequential conditions are changed during
execution of the program, the emulator temporarily disables all Event conditions to
change the settings. During this period, no Event conditions will be satisfied.
9. If the break condition before executing an instruction is set to the instruction followed
by DIVU and DIVS, the factor for halting a break will be incorrect under the following
condition:
If a break occurs during execution of the above DIVU and DIVS instructions, the break
condition before executing an instruction, which has been set to the next instruction,
may be displayed as the factor for halting a break.
10. If the break conditions before and after executing instructions are set to the same
address, the factor for halting a break will be incorrectly displayed. The factor for
halting a break due to the break condition after executing an instruction will be
displayed even if a break is halted by the break condition before executing an
instruction.
11. Do not set the break condition after executing instructions and BREAKPOINT
(software break) to the same address.
12. When the emulator is being connected, the user break controller (UBC) function is not
available.
- SH-2A, SH-2 E200F Emulator 1
- Contents 5
- 1.2 System Configuration 10
- Port Connector 23
- H-UDI port connector 25
- (Pin 1 mark) 25
- (top view) 25
- Dumping resistance (33 Ω) 27
- All pulled-up at 4.7 kΩ 27
- User system 27
- PVcc = I/O power supply 27
- _WDTOVF _WDTOVF 82
- G6K_2G_DC3V 83
- RENESAS SALES OFFICES 88
- Supplementary Information 90
Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Renesas SH7210 Series
(92 strony)Whirlpool RB17UPXL manuales
Manuales del propietario y guías del usuario para Hornos Whirlpool RB17UPXL.
Ofrecemos 1 manuales en pdf Whirlpool RB17UPXL para descargar gratis por tipos de documentos: Manual de usuario
Komentarze do niniejszej Instrukcji