Renesas SH7210 Series Instrukcja Użytkownika Pobierz pdf (Strona 61)

Figure 3.1 [Source] Window at Execution Halt (Sequential Break)

If the sequential condition, performance measurement start/end, or point-to-point for the internal

trace is set, conditions of Event Condition to be used will be disabled. Such conditions must be

enabled from the popup menu by clicking the right mouse button on the [Event Condition] sheet.

Notes: 1. If the Event condition is set for the slot in the delayed branch instruction by the

program counter (after execution of the instruction), the condition is satisfied before

executing the instruction in the branch destination (when a break has been set, it occurs

before executing the instruction in the branch destination).

2. Do not set the Event condition for the SLEEP instruction by the program counter (after

execution of the instruction).

3. When the Event condition is set for the 32-bit instruction by the program counter, set

that condition in the upper 16 bits of the instruction.

4. If the power-on reset and the Event condition are matched simultaneously, no condition

will be satisfied.

5. Do not set the Event condition for the DIVU or DIVS instruction by the program

counter (after execution of the instruction).

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 89 90

Brak uwag

Renesas SH7210 Series Instrukcja Użytkownika Strona 61