Renesas M32R-FPU Instrukcja Użytkownika Pobierz pdf (Strona 23)

M32R Debugger and Trace 2 3 T r O n c h i p

TrOnchip.RESet Resets all TO settings

Resets the trigger system to the default state.

TrOnchip.VarCONVert Convert variable breakpoints

When enabled (default) the on-chip breakpoints are automatically converted from a range to a single

address if required. If the switch is off, the system will only accept breakpoints which exactly fit to the on-chip

breakpoint hardware.

The ICE-breaker does not provide resources to set an on-chip breakpoint to an address range. Only bit

masks can be used to mark a memory range with a breakpoint.

If TrOnchip.VarCONVert is set to ON and a breakpoint is set to a scalar variable then it is converted into a

single address breakpoint.

If TrOnchip.VarCONVert is set to OFF variable breakpoints will be set to an address range covering the

whole variable.

TrOnchip.view Opens configuration panel

Control panel to configure the on-chip breakpoint and trace registers. The details are described in section

TrOnchip.

Format: TrOnchip.RESet

Format: TrOnchip.VarCONVert [OFF | ON]

Format: TrOnchip.view

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Brak uwag

Renesas M32R-FPU Instrukcja Użytkownika Strona 23