Renesas M16C/30P Instrukcja Użytkownika Pobierz pdf (Strona 23)

E8a Emulator Section 7 Debugger Setting

[Power supply]

When supplying power to the user system from the E8a, click the [Power Target from Emulator. (MAX 300mA)]

check box.

3. [Firmware Location] tab

For details, see “1. Program area for the E8a emulator” and “7. Debugging using the watchdog timer” in “Section 6.

Notes on Using the E8a Emulator”.

4. [MCU Setting] Tab

In the [MCU Setting] tab, set the operating condition of the MCU used in the user system.

Figure 7.3 [MCU Setting] Tab

Specify processor mode

Specify the processor mode according to the user system. One of the following can be specified:

- Single-Chip Mode

- Memory Expansion Mode

PM10 (b0 of 000005H) is ‘1’

Specify whether PM10 (zero bit of processor mode register 1) is set. When using the user program with PM10 set

to “1”, check this option.

Notes:

The following describes precautions to be taken when using the emulator in memory expansion mode:

- When the external area cannot be rewritten via normal memory access, software breaks cannot be used in that area.

- No address match break can be used in the external memory space.

- The “Go to Cursor” function cannot be used in the external memory space. If this function is used in the external

memory space, the program will be in a state of execution.

REJ10J1639-0500

Rev.5.00 Page 20 of 23

Apr.30.10

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29

Brak uwag

Renesas M16C/30P Instrukcja Użytkownika Strona 23