Renesas Emulator Debugger M16C PC4701 Instrukcja Użytkownika Pobierz pdf (Strona 16)

( 16 / 52 )

Chapter 2. Preparation

2.1 Terminology

Some specific words used in this user's manual are defined as follows:

Emulator system

This means an emulator system built around the PC4701 emulator. The PC4701 emulator system is

configured with an emulator main unit, emulation pod, pod probe, host machine and emulator debugger.

Emulator main unit (Hereafter PC4701)

This means a generic name for emulators for 8 and 16-bit MCUs. For details on specific models of

PC4701, visit the Renesas Tools Homepage at http://www.renesas.com/en/tools

Emulation pod

This means the M30100T-RPD-E (this product). This emulation pod is for the M16C/10 Series MCUs.

Pod probe

This means pod probe M301xxT-PRB for the M16C/10 Series MCUs ("x" denotes a number).

Host machine

This means a personal computer used to control the emulator and emulation pod.

Emulator debugger

This means a software tool M3T-PD30 to control the emulator from the host machine through an

interface.

Firmware

Program that analyzes contents of communication with the emulator debugger and controls the

emulator hardware. This program is installed in the EEPROM. This program is downloadable from

the emulator debugger to upgrade the firmware or to support other MCUs.

Software break

A software break is a function to break the program before the system executes an instruction at the

specified address. The instruction at the preset address will not be executed.

Hardware break

A hardware break is a function to break the program when the system detects a write/read of data to/

from memory or a rise/fall edge of the signal entered from the external trace cable. The former break

function is called data break; and the latter break function is called trigger break. While the instruction

at the address where the software break is set is not executed, a hardware break is performed after the

specified instruction is executed.

Evaluation MCU

This means the microcomputer mounted on the emulation pod which is operated in the specific mode

for tools.

Target MCU

This means the microcomputer you are going to debug.

Target system

This means a user's application system using the microcomputer to be debugged.

In this user's manual, this symbol is used to show active Low. (e.g. RESET*: Reset signal)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Brak uwag

Renesas Emulator Debugger M16C PC4701 Instrukcja Użytkownika Strona 16